X1-010 instrument editor

X1-010 instrument editor contains three tabs: Sample, Wavetable and Macros.

Sample

for sample settings, see the Sample instrument editor.

the only differences are the lack of an "Use wavetable" option, and the presence of a "Use sample" one.

there also is a "Sample bank slot" setting, but I think that does nothing for now.

Wavetable

this allows you to enable and configure the Furnace wavetable synthesizer. see this page for more information.

Macros

• Volume: volume levels sequence.
• Arpeggio: pitch sequence.
• Waveform: waveform selection sequence.
• Panning (left): output level for left channel.
• Panning (right): output level for right channel.
• Pitch: fine pitch.
• Envelope Mode: sets up envelope. the way it works is kind of complicated and even I don't understand how it works, so it's not documented for now.
• Envelope: specifies which wavetable should be used for envelope.
• AutoEnv Num: sets the envelope to the channel's frequency multiplied by numerator.
• AutoEnv Den: sets the envelope to the channel's frequency divided by denominator.
• the X1-010 hardware envelope is considerably slower than AY's. beware!
• these two must be set in order for AutoEnv to work!